Qmark Ceiling Fan Accessories - Manual (Page 3)

Figure 7 - Hang Fan & Guard Figure 9 - Attach “Secondary Support Cable”
6. Install last quarter section of fan guard as in item
two above and attach guard to clamp.
(See Figure 8)
Figure 8 - Install Final Quarter
To obtain maximum holding power, install U-bolt
section of clip on dead or short end of cable and
saddle on long end of cable. Improper installation
reduces the efficiency of the connection by as much as
40 percent.
NOTE: Cable must have at least 3 inches but no more
than 5 inches of slack.
NOTE: Additional hardware may be required, which
is available at your local hardware store.
IMPORTANT: LEAVE SLIGHT SLACK IN BOTH FAN
“SECONDARY SUPPORT” CABLE AND GUARD
“SECONDARY SUPPORT” CABLE TO AVOID
RESTRICTION. MAKE SURE GUARD “SECONDARY
SUPPORT’ CABLE WILL NOT COME IN CONTACT
WITH REVOLVING FAN BLADES.
5. Hang fan from factory supplied “J” hook at the
beam. (See Figure 7)
7. IMPORTANT: After fan guard is completely
assembled and mounted, securely attach the
“secondary support” cable to or around any
structural member that will support 300 pounds as
indicated in
Figure 9
Figure 10 - “Secondary Support Cable” Clamp Positions
CAUTION: Top and bottom quarter guard sections
MUST be bolted together as shown above. This will
maintain balance of guard.
3