Pro-Tools EMN-510 - Manual (Page 9)

QUALITY PRODUCTS MADE BY PEOPLE WHO CARE PRO-TOOLS (813) 986-9000
PAGE 9
GODZILLA
END MILL NOTCHER
ALLEN WRENCH
V-BLOCK ADJUSTMENT BOLT
CENTER
PUNCH
SPACER SHIM
INSTRUCTIONS:
1) IT WILL BE NECESSARY TO CUT SEVERAL SMALL LENGTHS OF TUBE FOR TESTING PURPOSES.
2) TO ADJUST V-BLOCK (LOOSEN BOLTS IN REAR, INSERT SPACER SHIM UNDER V-BLOCK HEIGHT
YOU NEED. TIGHTEN BOLTS ON REAR OF V-BLOCK. (TAKE THE SPACER SHIM OUT & KEEP IN
TOOLBOX)
3) INSTALL TUBES ONE AT A TIME MAKING 90 DEGREE CUT AND ADJUSTING THE V-BLOCK AS
NECESSARY TILL TUBE NOTCHES ON CENTER.
4) ONCE YOU HAVE COMPLETED YOUR TEST NOTCH AND ARE SURE IT IS CUTTING ON CENTER
IT WILL BE NECESSARY TO CENTER PUNCH SIDE OF V-BLOCK SO THAT IT LINES UP WITH THE
ZERO. ONCE THIS IS COMPLETED YOU WILL HAVE A REFERENCE SO THAT YOU CAN RAISE OR
LOWER THE BLOCK FOR OFFSET NOTCHING AND RETURN FOR CENTER CUTS WITH NO PROBLEM.