Pro-Tools EMN-510 - Manual (Page 11)

END MILL NOTCHER
FAQ’s
QUALITY PRODUCTS MADE BY PEOPLE WHO CARE PRO-TOOLS (813) 986-9000
PAGE 11
Q: WHAT TYPE OF MATERIAL CAN I NOTCH?
A: YOU CAN NOTCH UP TO 2” SCHEDULE 40 OR 2 3/8” O.D.
Q: HOW MUCH OF AN ANGLE CAN I NOTCH?
A: YOU CAN NOTCH ANYWHERE FROM 0-90 DEGREES.
Q: ARE ALL PARTS MADE IN THE USA?
A: YES, ALL MACHINED PARTS ARE CNC MACHINED AT OUR FACILITY AND ALL OTHER
PARTS ARE ALSO USA MADE.
Q: WHAT KIND OF POWER SOURCE DOES IT COME WITH?
A: THE POWER SOURCE IS A HEARTY 1 ½ HP 110V MOTOR WITH A GEAR REDUCTION
Q: WHAT TYPE OF END M ILLS SHOULD I USE?
A: USE STANDARD END MILLS UP TO 2 3/8”
Q: CAN I UPGRADE TO LARGER OR VARIABLE SPEED MOTOR.
A: NO, THIS MOTOR PACKAGE IS THE BEST CHOICE FOR THIS CONFIGURATION.
Q: IF SOMETHING BREAKS CAN I GET A REPLACEMENT PART.
A: YES. IF IT IS NOT COVERED BY THE WARRANTY YOU CAN CONTACT OUR SALES
DEPARTMENT AND THEY WILL ASSIST YOU IN GETTING THE CORRECT PART.