Pro-Tools EMN-510 - Manual (Page 6)

QUALITY PRODUCTS MADE BY PEOPLE WHO CARE PRO-TOOLS (813) 986-9000
PAGE 6
GODZILLA
END MILL NOTCHER
OPERATING INSTRUCTIONS
NOTCHER USE:
•LUBRICATE ALL MOVING PARTS WITH WD-40 OR LITHIUM GREASE
•SET VICE AT DESIRED ANGLE AND POSITION TUBE IN THE CENTER OF THE
CUTTER (SEE SHEET 5)
•TURN MOTOR ON AND SLOWLY TURN THE LARGE WHEEL TO FEED CUTTER
INTO TUBE. (DANGER: DO NOT LET END OF CUTTER COME IN CONTACT WITH
TUBE)
•AFTER EACH DAYS USE, ALL SLIDE RAILS SHOULD BE CLEANED AND OILED.
ON CUTTERS WITH SMALLER
THAN A 1 ¼” SHANK, A BUSHING
IS REQUIRED.
TIGHTEN SET-SCREW ON FLAT
AREA ON THE CUTTER SHANK (IF
NECESSARY, GRIND FLAT.)
WHEN CUTTING TUBE,
ALWAYS NOTCH OFF THE
SIDE OF THE CUTTER.
(NEVER USE THIS END)
DEGREE INDICTATOR ON SIDE OF VISE
BOTH SLIDE TRACKS HAVE BRASS
ADJUSTER BARS TO RESTRICT
UNNECESSARY MOVEMENT. ADJUST
THE ¼-20 SOCKET HEAD CAP SCREW
TO ACHIEVE THE DESIRED TENSION.