Pro-Tools HB-302 One Shot - Manual (Page 6)

HB-302 BENDER
MEASURING DEGREE OF BEND
813-986-9000 PAGE 6
YOUR “ONE SHOT” BENDER IS EQUIPPED WITH A TRAVEL
ROD WITH STOP. ON THIS TYPE OF BENDER, DEGREE OF
BEND IS DETERMINED BY INCHES OF TRAVEL ON THE ROD.
IT WILL BE NECESSARY TO “DEGREE” EACH DIE AND MAKE
A CHART OF HOW MUCH TRAVEL IS NECESSARY TO
ACCOMPLISH YOUR BEND.
DEGREE OF BEND LOOSEN KNOBS AND
SLIDE V-BLOCK OUT
UNTIL IT SITS SQUARE
ON THE TUBE.
LOOSEN KNOBS AND
SLIDE V-BLOCK OUT
UNTIL IT SITS SQUARE
ON THE TUBE.
THE ILLUSTRATION BELOW SHOWS OUR PART #302DI DEGREE
INDICATOR MOUNTED ON THE BENDER.
PRO-TOOLS