Pro-Tools HB-302 One Shot - Manual (Page 2)

HB-302 BENDER
INSTRUCTION SET
813-986-9000 PAGE 2
DANGER
PLEASE READ
NEVER START BEND WITH
THE TUBE TOO SHORT.
TUBE MUST ALWAYS
EXTEND TO END OF
ALUMINUM BAR OR PAST.
NEVER DO THIS!!!
2”
WHEN BENDING NEVER LET ALUMINUM
BAR GO ANY FARTHER THAN SHOWN BELOW.
IF YOUR BAR HAS MOVED AS FAR
AS SHOWN AND YOU HAVE NOT
COMPLETED THE BEND, RELEASE
THE PRESSURE AND SLIDE BAR
BACK TO THE RIGHT AND THEN
FINISH THE BEND.
ALWAYS BE SURE THAT THE PIN PROTUDES
THROUGH LOWER PLATE, AS SHOWN.
DANGER
THIS BENDER OPERATES
UNDER 15 TONS OF PRESSURE.
PLEASE FOLLOW ALL INSTRUCTIONS
CAREFULLY!
PRO-TOOLS