Bending instructions, Page 6, Fig. a – Pro-Tools MB-105 User Manual
Page 6: Fig. b fig. c, Fig. d
PAGE 6
QUALITY PRODUCTS BY PEOPLE WHO CARE
(813) 986-9000
BENDING INSTRUCTIONS
ENGAGE RATCHET AS SHOWN.
PULL HANDLE IN DIRECTION
OF ARROW.
FIG. A
CONTINUE TO WORK THE RATCHET
UNTIL YOU HAVE REACHED THE END,
AS SHOWN IN FIG. C.
FIG. B
FIG. C
WHEN YOU HAVE BENT THE TUBING AS MUCH AS
THE FIRST POSITION WILL ALLOW, DISENGAGE THE
RATCHET & REMOVE THE 7/8” DRIVE PIN. ROTATE
THE SWING ARM COUNTER-CLOCKWISE UNTIL THE
DRIVE PIN CAN BE REINSTALLED THROUGH
ANOTHER HOLE IN THE BENDING DIE. BE CAREFUL
NOT TO MOVE THE TUBE. NOW REPEAT THE ABOVE
BENDING SEQUENCE UNTIL THE DESIRED DEGREE
OF BEND IS OBTAINED.
FIG. D