Pro-Tools MB-105 - Manual (Page 14)

FAQ’s
Q: CAN THE BENDER BE CONVERTED TO HYDRAULIC?
A: YES, WE CARRY A HYDRAULIC CONVERSION KIT THAT USES EITHER AIR OR
ELECTRIC.
Q: WHAT IS THE BIGGEST TUBE SIZE I CAN BEND?
A: WITH THE MB-105-HD BENDER THE MAXIMUM TUBE DIAMETER IS 2”O.D. THE
MB-105 STANDARD CAN BEND A MAXIMUM DIAMETER OF 1.75” O.D.
Q: HOW MANY DEGREES CAN THIS UNIT BEND?
A: DEPENDING ON THE DIE YOU CAN CHOOSE FROM 120 DEGREE DIE FOR 90 DEGREE
BENDS, OR YOU CAN CHOOSE THE 240 DEGREE DIE THAT WILL BEND 180 DEGREES.
Q: HOW DO I PREVENT THE TUBE FROM SCRATCHING OR MARRING?
A: TO LIMIT MARRING CONTACT OUR SALES DEPARTMENT FOR DELRIN BACKING
BLOCKS. THESE ARE A MUST IF YOU PLAN ON BENDING STAINLESS STEEL OR
HIGHLY POLISHED ALUMINUM.
Q: CAN I DO REPEAT BENDS WITH THE MB-105?
A: YES YOU CAN. WE CARRY A DEGREE RING (#MB-105 DS) WHICH COMES WITH A
DEGREE STOP SO THAT YOU CAN GET RELIABLE CONSISTENT BENDS EVERY TIME.
Q: THE TUBE IS STUCK IN THE BENDER AFTER COMPLETING A BEND?
A: LOOK TO PAGE 12 OF THIS MANUAL FOR INSTRUCTIONS ON HOW TO REMEDY THIS.
PAGE 14
QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000