Pro-Tools MB-105 - Manual (Page 4)

PAGE 4
QUALITY PRODUCTS BY PEOPLE WHO CARE (813) 986-9000
ASSEMBLY INSTRUCTIONS
MAIN DIE INSTALLATION
REMOVE 1” PIN, LUBRICATE PIN AND
DIE SLEEVE, PLACE DIE IN BENDER
FRAME THEN SLIDE PIN THOUGH FRAME
AND DIE SLEEVE (AS SHOWN)
INSERT PIN THOUGH SWING ARM
AND FIRST HOLE OF MAIN DIE.
DIE SLEEVE
TUBE & BACKING BLOCK INSTALLATION
1. BENDER SWING ARMS MUST BE CLOSED
POSITION AGAINST BENDER FRAME.
2. INSERT TUBE INTO RADIUS OF MAIN
DIE.
3. PUSH BACKING BLOCK AS
TIGHTLY AS POSSIBLE
AGAINST TUBE, THEN INSERT
PIN THROUGH BENDER
FRAME AND BLOCK.
STRAP & PIN INSTALLATION
PUSH FIRMLY ON THIS END OF TUBE,
PLACE STRAP AROUND TUBE, LINE UP
HOLES, THEN INSERT PIN THROUGH
STRAP AND DIE TAB.
PIN
STRAP