beautypg.com

Two-way chute control, Chute directional control, Wheel steering controls – Cub Cadet WO STAGE SNOW THROWER 930 SWE User Manual

Page 13: Chute clean-out tool, Control direccional del canal

background image

Two-Way Chute Control™

The two-way chute control is located on the left side of the dash

panel and is used to control the distance of snow discharge from

the chute.

To change the upper chute angle to control the distance

that snow is thrown, pivot the lever forward or backward.

Move the lever forward to pivot the upper chute down and

reduce the distance snow is thrown.

Move the lever rearward to pivot the upper chute upward

and increase the distance snow is thrown

Chute Directional Control

The chute directional control is located on the left side of the

snow thrower.

To change the direction in which snow is thrown, crank

clockwise to discharge to the left and counterclockwise to

discharge to the right.

Wheel Steering Controls

The left and right wheel steering controls are located on the

underside of the handles. Squeeze the right control to turn right;

squeeze the left control to turn left.
NOTE: Operate the snow thrower in open areas until you are

familiar with these controls.

Chute Clean-Out Tool

WARNING!

Never use your hands to clear a

clogged chute assembly. Shut off engine and remain

behind handles until all moving parts have stopped

before unclogging.

The chute clean-out tool is conveniently fastened to the rear of

the auger housing with a mounting clip. Should snow and ice

become lodged in the chute assembly during operation, proceed

as follows to safely clean the chute assembly and chute opening:

Release both the Auger Control and the Drive Control.

1.

Stop the engine by removing the ignition key.

2.

Remove the clean-out tool from the clip which secures it to

3.

the rear of the auger housing.
Use the shovel-shaped end of the clean-out tool to

4.

dislodge and scoop any snow and ice which has formed in

and near the chute assembly.
Refasten the clean-out tool to the mounting clip on the

5.

rear of the auger housing, reinsert the ignition key and

start the snow thrower’s engine.
While standing in the operator’s position (behind the snow

6.

thrower), engage the auger control for a few seconds to

clear any remaining snow and ice from the chute assembly.

CHUTE DIRECTIONAL CONTROL

DISCHARGE

LEFT

DISCHARGE

RIGHT

CHUTE TILT

DOWN

CHUTE TILT

UP

DESCARGA

A LA

DERECHA

DESCARGA A

LA IZQUIERDA

INCLINACIÓN DEL

CANAL HACIA

ABAJO

INCLINACIÓN DEL

CANAL HACIA ARRIBA

CONTROL DIRECCIONAL DEL CANAL

13

s

ectiOn

4 — c

OntrOls

and

f

eatures

This manual is related to the following products: