Canon IMAGE FORMULA DR-3010C - Manual (Page 20)

Chapter 2 Basic Operation
- 15 -
When scanning multiple page documents that are fastened together, such as
invoices, place the documents so that the top (or the edge that is fastened
together) is fed through the scanner first.
1
Switch the feed selection lever to (Bypass).
2
Adjust the document guides to fit the width of the document to be scanned.
(See p.13.)
3
Place the document face down, with the top (or the edge that is fastened
together) fed through the scanner first. (See p.13.)
4
Use the application software to start scanning.
IMPORTANT
•
When placing documents that are fastened together, such as invoices, place the
fastened side of the document so that it is fed through the scanner first.
•
After you finish scanning, close the document eject tray to prevent damage to the
scanner while it is not being used.
1
Switch the feed selection lever to (Bypass).
IMPORTANT
When scanning cards, make sure to set the feed selection lever to (Bypass),
and scan the cards one at a time.
2
Adjust the document guides to fit the width of the card to be scanned. (See
p.13.)
Feeding in the Bypass Mode
Placing Cards