Dell Inspiron 1410 (Late 2008) - Manual (Page 16)

1. Remove the display assembly (see Display ).
2. Remove the display bezel (see Removing the Display Bezel ).
3. Remove the six screws securing the display panel assembly to the display cover.
4. Disconnect the cables from the connectors on each end of the inverter board.
5. Remove the display panel assembly.
6. Remove the eight screws (four on each side) that secure the display panel brackets to the display panel.
Replacing the Display Panel
1. Align the display panel brackets with the display panel.
2. Replace the eight screws that secure the display panel brackets to each side of the display panel.
NOTE: Make a note of the routing of the cables behind the display panel.
1 display panel 2 screw (6)
3 display inverter 4 display cover
1 display panel bracket
(1 left; 1 right) 2 display bracket screw
(8 total; 4 on each side)
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.