Cleveland Range SteamChef 22CGT6 - Manual (Page 14)

7
SHUTDOWN INSTRUCTIONS
1) TURN OFF THE ON/OFF LEVER/SWITCH.
2) WAIT FOR THE 3-MINUTE DRAIN RINSE CYCLE TO RUN.
3) TURN OFF THE MAIN EXTERNAL POWER SWITCH.
4) TURN OFF THE MAIN MANUAL GAS VALVE.
2. In the Event of a Power Failure
• In the event of a power failure, do NOT attempt to operate this appliance.
I. To Preheat the SteamChef
Preheating the SteamChef helps ensure productivity and consistency. Preheat before cooking, and
reheat as needed between batches of food.
BEFORE PREHEATING inspect and clean the compartment. After preheating, the compartment will
be too hot to inspect and clean safely.
To preheat the SteamChef:
a. Turn the SteamChef ON 15 minutes before cooking to allow time for the water reservoir to fill and
SteamChef to heat:
1) Close the SteamChef door.
2) Select Timed mode.
3) Set the Timer to 0.
4) Turn ON the ON/OFF lever.
b. The SteamChef heats to the standby temperature.
J. High Limit Lockout
This SteamChef has a High Limit Lockout to protect the SteamChef from overheating.
1. If the SteamChef reaches the high limit temperature, the RESET light turns ON, a buzzer sounds
continuously, and the burner shuts OFF.
• The SteamChef must be reset before cooking can continue.
2. If the SteamChef overheats and locks out while cooking, open the door and check if there is water
in the reservoir.
• If there is no water in the reservoir:
a. Turn OFF the SteamChef
b. Wait for the SteamChef to cool
c. Clean the water level probes
d. Reset the High Limit Lockout (See Step 3.)
e. Restart the SteamChef.
• If there is water in the reservoir at the operating level:
a. Turn OFF the SteamChef and wait for the reservoir to drain.
b. Wait for the SteamChef to cool
c. Clean the water level probes
d. Reset the High Limit Lockout (See Step 3.)
e. Restart the SteamChef.
• If the problem repeats, call your qualified Cleveland Range authorized service representative
to adjust or repair the SteamChef.