Vermont Casting VCS5037 - Manual (Page 26)

Page 8
Step 17: Install the LP Cylinder (LP Models Only)
Parts Required:
Note:
(1) LP Gas Cylinder (not included)
Check your user’s manual for the cylinder filling
requirements, how to attach the regulator and how to test
for leaks before you try lighting the grill.
Place the LP Cylinder into the hole in the bottom panel.
Next secure it from moving by lifting the Cylinder
retainer wire and latching the bent edge over the lip of
the Cylinder. The final step is to connect the
to
the .
Caution:
Note:
Caution:
Note:
Make sure the hose is not touching any hot
surfaces.
For Models VCS5007, VCS5017, VCS5027 &
VCS5037, refer to Tank Pull-out assembly instructions
included with the Tank Pull-out kit.
Regulator
Cylinder
Do not turn on the grill until after performing a
leak check at all connection points and fittings. Use a
spray solution of 50% dish soap and 50% water onto all
connection points and fittings. Formation of bubbles
indicates air leaks.
Ensure all plastic coatings have been removed
from all stainless steel parts before using the grill.
Fig. 17a
Fig. 17b
CFM Corporation
410 Admiral Boulevard
Mississauga, Ontario L5T 2N6 Canada
(800) 668-5323
www.cfmcorp.com
Service Note: If you are experiencing difficulties or are dissatisfied with your purchase, please contact CFM at
the telephone number listed above prior to returning your grill to the store.
VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 / 27 37 Assembly VCS50 / VCS50