Vermont Casting VCS5037 - Manual (Page 21)

Page 3
Step 4: Install the Side Shelf Supports
Parts Required:
Note:
Step 5: Attach Shelves
Parts Required:
(1) Left Side Shelf Support
(1) Left Condiment Tray
(1) Right Side Shelf Support
(1) Right Condiment Tray
(8) 1/4-20 x 1-1/2“ Bolts
Only the right side assembly is shown in Fig. 4a
and Fig. 4b. To install Left Side Support and Condiment
Tray, repeat this step for the left side.
On the right side of the barbecue there are four threaded
inserts, screw a bolt half way into each of the four
threaded inserts. You will notice the bottom slot of the
support has a 'Y' shaped slot and a 'keyhole' shaped hole
above it. Take the Right Side Shelf Support and slide the
top screw into the 'keyhole' and the bottom screw into the
opening of the 'Y' shaped slot. Now take the Right
Condiment Tray and align its holes over the two front
bolts and gently push down until the bolts settle into the
grooves of the tray.
Next: Gently push down on the support until the screw
settles into the top of the groove. Do not fully tighten the
support screws at this point.
(1) Right Shelf - S/B (Shown)
(1) Left Shelf - Solid
Place the Right Shelf - S/B (shown) on top of the
supports making sure the holes are aligned and then snap
into place on the supports. The inside lip of the shelf will
slide between the grill shell and the shelf supports.
Fig. 4a
Slide
Push
Bolts
Bolts
Fig. 4b
VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 / 27 37 Assembly VCS50 / VCS50
Fig. 5
Slide End
On First
Then Snap
Into Place