Vermont Casting VCS5037 User Manual

Page 24

Page 6

Step 12: Attach the Handle to the Door

Parts Required:

Note:

VCS4007/VCS4017/VCS4027/VCS4037: (1) Handle
VCS5007/VCS5017/VCS5027/VCS5037: (3) Handles

VCS5007 VCS50

VCS50

5037

(1) Grease Cup
(1) Grease Pan

Install the Grease Cup into the cut-out in the Upper Base
Panel located underneath the grill. It is accessible from
the back of the grill. Once the Grease cup is in place,
move the Grease pan into position above it by placing
the side edges onto the support rails and sliding it into
place.

Make sure the funnel opening of the grease pan is

positioned over the Grease Cup.

(2) #10-24 x 1/2” Bolts (black)
(1) Stabilizer Bracket

Attach the Stabilizer Bracket underneath the bottom
panel by aligning the holes and inserting both #10-24 x
1/2” bolts through the panel and into the Stabilizer
Bracket as shown in Fig. 14.

Handles may not appear exactly as shown in

diagram

Attach the Door handle(s) to the door(s) by aligning the
handles over the holes and inserting the screws that were
supplied with the handles through the door panel and into
the handles. For models

17,

& VCS

, attach the drawer handle using the same

method.

If doors are not aligned or have shifted during

shipping, they can be adjusted by loosening the screws
which fasten the hinge of the door to the grill body and
shifting the doors until they are aligned. Once satisfied
with alignment, fully tighten the screws to secure the
doors into position.

Step 13: Install the Grease Cup and Grease Pan

Parts Required:

Note:

Step 14: Attach Stabilizer Bracket

Parts Required:

Fig. 13

Stabilizer Bracket

Fig. 14

VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 /

37 Assembly

VCS50

/ VCS50