Camera module, Removing the camera module, 9 lift the camera module from the display cover – Dell Inspiron 15 (N5040, Mid 2011) User Manual
Page 67
Camera Module
67
16
Camera Module
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 13) before working inside the computer.
Removing the Camera Module
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery (see "Removing the Battery" on page 13).
3 Follow the instructions from step 3 to step 8 in "Removing the Palm-Rest
4 Remove the hinge cover (see "Removing the Hinge Cover" on page 53).
5 Remove the display assembly (see "Removing the Display Assembly" on
6 Remove the display bezel (see "Removing the Display Bezel" on page 61).
7 Disconnect the camera cable from the connector on the camera module.
8 Release the two tabs that secure the camera module to the display cover.
9 Lift the camera module from the display cover.