Dell U2711 Monitor - Manual (Page 26)

Display Settings
Wide Mode
Horizontal Position
Vertical Position
Sharpness
Noise reduction
Pixel Clock
Phase
Dynamic Contrast
Display Info
Reset Display Setting
Back
Adjusts the image ratio as 4:3 or full screen.
NOTE: Wide Mode adjustment is not required at maximum preset resolution 2560 x 1440.
Use the and buttons to adjust image left and right. Minimum is '0' (-). Maximum is '100' (+).
Use the and buttons to adjust image up and down. Minimum is '0' (-). Maximum is '100' (+).
This feature can make the image look sharper or softer. Use or to adjust the sharpness from '0' to '100' .
Improve the motion picture quality by reducing noise on image edge.
The Phase and Pixel Clock adjustments allow you to adjust your monitor to your preference. These settings are accessed through the main OSD menu, by selecting
'Image Settings'.
Use the and buttons to adjust for best image quality.
If satisfactory results are not obtained using the Phase adjustment, use the Pixel Clock (coarse) adjustment and then use Phase (fine), again.
NOTE: Pixel Clock and Phase Adjustments are only available for "VGA" input.
Allows you to increase the level of contrast to provide sharper and more detailed image quality.
Displays the monitor's current settings.
Resets the display settings to the original factory settings.
Touch to go back to the main menu.
Audio Settings Use the Audio Settings menu to adjust the audio settings.