Dell POWEREDGE M915 - Manual (Page 3)

Installation And Configuration
WARNING: Before performing the following procedure, review the safety instructions that came with the blade
server or enclosure.
NOTE: The system is intended for restricted access location in accordance with the National Electric Code,
National Standards Institute (ANSI/National Fire Protection Association (NFPA) 70.
Unpacking The System
Unpack your blade server or enclosure and identify each item.
Installing The Enclosure In The Rack
Figure 1. Installing the Enclosure in the Rack
Assemble the rails and install the enclosure in the rack, following the safety instructions and the rail installation
instructions that shipped with the rail kit.
Installing A Sleeve In The Enclosure
NOTE: This procedure applies only to PowerEdge M420.
A sleeve includes up to four quarter-height blades to function as a system. Depending on your order, the sleeve may
ship with the blades preinstalled.
CAUTION: Exercise utmost care when installing or removing the sleeve to prevent damage to the internal
components. To ensure protection for the electronic components inside, follow the Electrostatic Discharge (ESD)
guidelines.
3