Dell OptiPlex 780 - Manual (Page 13)

Sets the power management suspend mode to:
S1
S3 (default)
NOTE: If the AMT Management Engine (ME) of the system is disabled, the S1 suspend mode is
unavailable in the system setup.
Fan Control
Override Controls the speed of the system fan.
NOTE: When enabled, the fan runs at full speed.
Maintenance
Service Tag Displays the Service Tag of your computer.
Asset Tag Allows you to create a system asset tag if an asset tag is not already set.
This option is not set by default.
SERR Messages Controls the SERR Message mechanism.
This option is enabled by default.
Some graphics cards require the SERR Message mechanism be disabled.
Image Server
Lookup Method Specifies how the ImageServer looksup the server address.
Static IP
DNS
NOTE: You must set the Integrated NIC to Enable with ImageServer to set the Lookup
Method.
ImageServer IP Specifies the primary static IP address of the ImageServer with which the client software
communicates.
The default IP address is 255.255.255.255
NOTE: You must set the Integrated NIC to Enable with ImageServer to set the ImageServer
IP.
ImageServer Port Specifies the primary IP port of the image server with which the client software communicates.
The default IP port is 06910.
Client DHCP Specifies how the client obtains the IP address.
Static IP
DHCP (default)
Client IP Specifies the static IP address of the client.
The default IP address is 255.255.255.255
NOTE: To set Client IP you must set Client DHCP to Static IP
Client
SubnetMask Specifies the subnet mask for the client.
The default setting is 255.255.255.255
NOTE: To set Client SubnetMask you must set Client DHCP to Static IP
Client Gateway Specifies the gateway IP address for the client.
The default setting is 255.255.255.255
NOTE: To set Client SubnetMask you must set Client DHCP to Static IP
License Status Displays the current license status.