Dell Inspiron B120 - Manual (Page 20)

20
Setting Up Your Computer
• If you have already obtained setup information from your ISP but you did not receive a setup CD,
click Set up my connection manually.
• If you have a CD, click Use the CD I got from an ISP.
5 Click Next.
If you selected Set up my connection manually, continue to step 6. Otherwise, follow the instructions
on the screen to complete the setup.
NOTE:
If you do not know which type of connection to select, contact your ISP.
6 Click the appropriate option under How do you want to connect to the Internet?, and then click Next.
7 Use the setup information provided by your ISP to complete the setup.
If you are having problems connecting to the Internet, see " E-Mail, Modem, and Internet Problems ." If
you cannot connect to the Internet but have successfully connected in the past, the ISP might have a
service outage. Contact your ISP to check the service status, or try connecting again later.
Transferring Information to a New Computer
The Microsoft
®
Windows
®
XP operating system provides a Files and Settings Transfer Wizard to move
data from a source computer to a new computer. You can transfer data, such as:
• E-mail messages
• Toolbar settings
• Window sizes
• Internet bookmarks
You can transfer the data to the new computer over a network or USB connection, or you can store it on
a removable medium, such as a writable CD or floppy, for transfer to the new computer.
NOTE:
You can transfer information from the old computer to the new computer by directly connecting the two
computers with a USB cable. To transfer data over a USB connection, you must access the Network Connections
utility from the Control Panel and perform additional configuration steps, such as setting up an advanced
connection and designating the host computer and the guest computer.
For instructions on setting up a direct cable connection between two computers, see Microsoft Knowledge Base
Article #305621, titled How to Set Up a Direct Cable Connection Between Two Computers in Windows XP. This
information may not be available in some countries.
For transferring information to a new computer, you must run the Files and Settings Transfer Wizard.
You can use the optional Operating System CD for this process or you can create a wizard disk with the
Files and Settings Transfer Wizard utility.
Running the Files and Settings Transfer Wizard With the Operating System CD
NOTE:
This procedure requires the Operating System CD. This CD is optional and may not be included with all
computers.
book.book Page 20 Thursday, September 22, 2005 8:08 AM