Dell Inspiron Zino HD (400, Late 2009) - Manual (Page 22)

Back to Contents Page
I/O Bracket
Dell™ Inspiron™ 300/400 Service Manual
Removing the I/O Bracket
Replacing the I/O Bracket
Removing the I/O Bracket
1. Follow the procedures in Before You Begin .
2. Remove the top cover (see Removing the Top Cover ).
3. Remove the top bracket (see Removing the Top Bracket ).
4. Remove the I/O bezel (see Removing the I/O Bezel ).
5. Remove the chassis fan (see Removing the Chassis Fan ).
6. Using a hex nut driver, remove the two screws that secure the VGA connector to the I/O bracket.
7. Remove the screw that secures the I/O bracket to the chassis.
8. Carefully press and release the security lock latch on the I/O bracket out of the computer cover and lift the I/O bracket out of the computer.
Replacing the I/O Bracket
1. Follow the procedures in Before You Begin .
2. Slide the tabs on the bottom of the I/O bracket into the slots on the chassis.
3. Carefully press and slide the security lock latch into place. Replace the screw that secures the I/O bracket to the chassis.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1 screw 2 hex nut screws (2)
3 I/O bracket 4 security lock latch