Casio AP-38 - Manual (Page 19)

E-15
4.
Now try playing something on the keyboard.
• The lower range (left side) of the keyboard is assigned
the split tone, while the upper range (right side) is
assigned the main tone.
• The location on the keyboard where the changeover
between the two tones occurs is called the split point.
See “To change the location of the split point” on this
page for details on changing the location of the split
point.
5.
Press the SPLIT button again to unsplit the
keyboard and return it to normal.
• This causes the indicator lamp above the button to go
out.
❚ NOTE
• If you change or turn off a digital effect while split is turned on,
the setting you make is saved to the main tone’s settings only.
How digital effects are applied when split is
turned on
The following are the rules that determine what type of digital
effects are applied to tones that are assigned to a split
keyboard.
To change the location of the split point
The “split point” is the point on the keyboard that separates
the low range (split tone) from the high range (main tone).
1.
While holding down the SPLIT button, press the
keyboard key where you want the highest note
(the rightmost key) of the lower range (left side
range) to be.
• No sound is produced when the keys are pressed.
To adjust the volume of the split tone
1.
Hold down the CONTROL button, and keep it
depressed until you reach step 4 of this
procedure.
2.
Press the ELEC PIANO 1 button.
• This causes the indicator lamp above the button to
flash.
3.
Use one of the procedures below to set the split
tone volume to a value in the range of 40 to 127.
• To scroll the volume setting value: While holding
down the CONTROL button, use the + (increase) and
– (decrease) keys to scroll the volume setting value.
Holding down either key changes the setting at high
speed.
Pressing + and – at the same time automatically selects
a volume setting value of 127.
• To input the volume setting value: While holding
down the CONTROL button, use the number input
keys to input a two-digit or three-digit volume setting
value in the range of 40 to 127. You can input a two
digit or a three-digit value. The level you input is
applied to the volume setting value when you release
the CONTROL button. The volume setting does not
change if you input a one-digit value or a value that
is outside of the allowable range.
These conditions:
• Digital effects turned on
for the main tone
• Digital effects turned on or
off for the split tone
• Digital effects turned off
for the main tone
• Layering turned on (page
E-13)
• Digital effects turned on
for the layered tone
• Digital effects turned off
for the main tone
• Layering turned on (page
E-13), but digital effects
turned off for the layered
tone
• Layering turned off
• Digital effects turned on
for the split tone
Cause these digital effects to
be applied to both the main
tone and split tone:
Main tone digital effects
Layered tone digital effects
Split tone digital effects
C 3 B 2
+/–
keys
Number Input keys
428A-E-019A
• A note does not sound when you press a keyboard
key at this time.
4.
Release the CONTROL button to complete the
procedure.
❚ NOTE
• The setting you make for the split tone volume remains in effect
even if you change to another tone.
AP38_e_08-19.p65 02.6.12, 15:55 15