Dell XPS 720 H2C (Mid 2007) - Manual (Page 19)

Setting Up and Using Your Computer
19
CAUTION:
The computer stand should be installed at all times to ensure maximum system stability. Failure to
install the stand could result in the computer tipping over, potentially resulting in bodily injury or damage to the
computer.
1 Follow the procedures in "Before You Begin" on page 85.
2 Remove the thumb screw that is installed on the base of the computer.
NOTE:
If the thumb screw is not already installed in the stand, it has been packaged separately.
3 Insert the six alignment tabs into the corresponding slots on the base of the computer, then slide the
stand forward until all six tabs catch in the slots.
4 Ensure that the screw hole on the stand is aligned with the screw hole on the base of the computer.
5 Insert the captive screw into the screw hole, then tighten the screw to secure the stand to the base of
the computer.
6 With the help of an assistant, carefully set the computer upright.
7 Carefully, lift the rear of the computer and slide the stabilizing feet outward into the open position.
1 captive screw 2 stabilizing feet (closed) 3 computer stand
4 slots (6)
3
4
1
2