Display panel, Display latch – Dell Latitude D500 User Manual
Page 12
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
keyboard
.
3.
Remove the
.
4.
Use a plastic scribe to pry the six display bumpers out of the screw holes located on the front of the bezel.
5.
Remove the six M2 x 5-mm screws located on the front of the bezel.
6.
Starting at the bottom of the display panel (by the DELL™ logo), use your fingers to separate the bezel from the top cover by lifting the inside edge of
the bezel away from the top cover.
Display Panel
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
keyboard
.
3.
Remove the
.
4.
Remove the two M2 x 5-mm screws from each side of the display panel.
5.
Lift the display panel, and rotate the display panel out of the display cover.
6.
Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
7.
Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connenctor.
Display Latch
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Carefully separate the bezel from the top cover to avoid damage to the bezel.
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1 top flex-cable connector
2 display connector
3 pull-tab on bottom flex-
cable connector
4 inverter connector