Installing the coin-cell battery, Removing the wlan card, Installing the wlan card – Dell Vostro 14 (5480, Late 2014) User Manual
Page 16

Installing the Coin-Cell Battery
1.
Place the coin-cell battery into its slot on the computer.
2. Route the coin-cell battery cable along the routing channel.
3. Connect the coin-cell battery cable to its connector on the system board.
4. Install :
a.
b.
After Working Inside Your computer
Removing the WLAN Card
1.
Before Working Inside Your Computer
2. Remove:
a.
b.
3. Perform the steps as shown in the illustration:
a. Disconnect the antenna cable from the WLAN card.
b. Remove the screw that secures the WLAN card to the computer.
c. Remove the WLAN card from its slot on the system board.
Installing the WLAN Card
1.
Insert the WLAN card into its connector at a 45–degree angle.
2. Tighten the screw to secure the WLAN card to the computer.
3. Connect the antenna cables to their respective connectors marked on the WLAN card.
4. Install:
a.
b.
After Working Inside Your computer
16