Dell Latitude C400 - Manual (Page 21)

Display Assembly
1 display-feed flex cable
2 M2.5 x 12-mm screws (2)
3 display-feed flex cable hold-down board
4 pull tab
7. Remove the two M2.5 x 12-mm screws from the display-feed flex cable hold-down board.
8. Use the pull tab to disconnect the display-feed flex cable from its connector on the system board.
9. Move the display assembly to an upright position and pull it up out of the computer.
Replacing the Display Latch
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on
the computer.
NOTICE: Read " Preparing to Work Inside the Computer " before performing the following procedure.