Dell Precision 340 - Manual (Page 45)

S e t u p a n d Q u i c k Re f e r e n c e G u i d e 45
Solid yellow N/A The Dell Diagnostics is running a
test, or a device on the system board
may be faulty or incorrectly installed. If the Dell Diagnostics is running,
allow the testing to complete.
Check the diagnostic lights to see if
the specific problem is identified.
Also, see "System Board Problems" in
the
User’s Guide.
If the computer does not boot,
contact Dell for technical assistance.
Blinking yellow Blank A power supply or system board
failure exists. Check the diagnostic lights to see if
the specific problem is identified. See
"Power Problems" and "System Board
Problems" in the
User’s Guide.
Blinking yellow Solid green A system board failure exists. Check the diagnostic lights to see if
the specific problem is identified.
Also, see "System Board Problems" in
the
User’s Guide.
Solid green and a
beep code during
POST N/A A problem was detected while the
BIOS was executing. See "Beep Codes" on page 49 for
instructions on diagnosing the beep
code. Also, check the diagnostic lights
to see if the specific problem is
identified.
Solid green power
light and no beep
code and no video
during POST N/A The monitor or the graphics card may
be faulty or incorrectly installed. Check the diagnostic lights to see if
the specific problem is identified.
Also, see "Video Problems" in the
User’s Guide.
Solid green power
light and no beep
code but the
computer locks up
during POST N/A An integrated system board device
may be faulty. Check the diagnostic lights to see if
the specific problem is identified. If
the problem is not identified, contact
Dell for technical assistance.
S y s t e m L i g h t C o d e s (continued)
Power Light Hard-Drive Light Cause Corrective Action