Dell Inspiron 20 (3043, Mid 2014) - Manual (Page 36)

Replacing the Power-Status
Light Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the power status-light board into the alignment post on the display
bezel.
2 Align the screw holes on the power status-light board with the screw
holes on the display bezel.
3 Replace the screws that secure the power status-light board to the
display bezel and secure it with the tape.
4 Slide the power-status light cable into the power-status light board
connector and press down on the connector latch to secure the cable.
Post-requisites
Follow the instructions from step 3 to step 6 in “Replacing the Back Cover ”.
36