Dell UPS 2700R - Manual (Page 88)

88 |
Shutdown Criteria and Sequence
Shutdown Sequence
At the end of the shutdown procedure, when all servers have been shut down, the UPS itself may shut
down to avoid unnecessary discharge of its batteries, depending on its configuration. See Figure 48 for
the shutdown sequence.
Battery Capacity
Utility Failure
Shutdown After
Start of the
Shutdown Sequence
Delay Before
Shutdown
UPS Shut Off
100%
If Remaining Time Under
0%
Card Parameters UPS Parameters
Remaining Autonomy
Shutdown Duration
Shutdown If
Remaining
Capacity Under
Figure 48. Shutdown Sequence
Load Segments
Some UPS models are equipped with load segments. Load segments are sets of receptacles that can be
controlled through the Dell Network Management Card, providing an orderly shutdown and startup of
your equipment. Load segments are dependent on the UPS's Inverter. Shutdown of the Inverter causes
shutdown of the load segments (usually two load segments). Refer to the UPS user's guide for the
location of the load segments.