Display assembly, Removing the display assembly – Dell Alienware M11x R2 (Mid 2010) User Manual
Page 14
Back to Contents Page
Display Assembly
Alienware® M11x R2 Service Manual
Replacing the Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the base cover (see
Removing the Base Cover
).
3.
Remove the battery pack (see
Removing the Battery Pack
).
4.
Follow the instructions from
step 4
to
step 6
in
Removing the Hard Drive
.
5.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
6.
Disconnect the antenna cables from the Mini-Card(s).
7.
Note the routing of the Mini-Card antenna cables and remove them from the routing guides on the computer base.
8.
Turn the computer over and open the display as far as possible.
9.
Remove the hinge cover (see
Removing the Hinge Cover
).
10.
Remove the keyboard (see
Removing the Keyboard
).
11.
Remove the palm rest assembly (see
Removing the Palm Rest Assembly
).
12.
Pull the pull-tab to disconnect the display cable from the connector on the system board.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery Pack
) before working inside the
computer.
1
Mini-Card antenna cables