Dell Dimension 8300 - Manual (Page 21)

Back to Contents Page
Front Panel
Dell™ Dimension™ 8300 Series Service Manual
Removing the Front Panel
Removing the Front-Panel Insert
Removing the Front Panel
1. Shut down the computer through the Start menu.
2. Disconnect the computer power cable from the electrical outlet.
3. Remove the front-panel door by gently snapping it off the two hinge arms.
Removing the Front-Panel Insert
Remove the front-panel insert before you install the floppy drive:
1. Open the computer cover to a 90-degree angle.
2. Locate the insert that is in front of the drive bay that you want to use.
3. From inside the computer, press in the release tab of the insert.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.