Replacing the palm rest – Dell Studio 1457 (Late 2009) User Manual
Page 40

14.
Lift the palm rest off the computer base.
Replacing the Palm Rest
1.
Follow the instructions in
Before You Begin
.
2.
Route the following cables through the palm rest and connect them to the corresponding connectors on the system board:
l
power button cable
l
battery indicator cable
l
speaker module cable
l
touch pad cable
l
display cable
l
camera/microphone
3.
Align the palm rest with the computer base and gently snap the palm rest into place.
4.
Replace the four screws on the top of the palm rest.
5.
Turn the computer over.
6.
Replace the ten screws on the computer base.
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the hard drive (see
Replacing the Hard Drive
).
9.
Replace the Mini-Cards, if applicable (see
Replacing the Mini-Card
).
10.
Replace the memory modules (see
Replacing the Memory Module(s)
).
11.
Replace the base cover (see
Replacing the Base Cover
).
12.
Replace the battery (see
Replacing the Battery
).
13.
Replace any removed cards in the ExpressCard slot or 8-in-1 Media Card Reader.
Back to Contents Page
CAUTION:
Carefully separate the palm rest from the computer base to avoid damage to the palm rest.