Dell Inspiron 537 (Mid 2009) - Manual (Page 7)

5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
6. Replace the card retention bracket (see Replacing the Card Retention Bracket ).
7. Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
8. Remove the card's driver from the operating system.
9. To complete the removal procedure, see Configuring Your Computer After Removing or Installing a PCI/PCI Express Card .
Replacing PCI and PCI Express Cards
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Removing the Computer Cover ).
3. Remove the card retention bracket (see Removing the Card Retention Bracket ).
4. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
5. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
6. If you are installing the PCI Express card into the x16 card connector, position the card so the securing slot is aligned with the securing tab.
7. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
4 retention mechanism 5 PCI Express x1 card slot 6 PCI Express x1 card
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep
dust and dirt out of your computer.
1 fully-seated card 2 not fully-seated card 3 alignment bar
4 alignment guide 5 bracket within slot 6 bracket caught outside of slot
1 PCI Express x16 card 2 PCI Express x16 card slot 3 securing tab