Installing a flash card reader – Dell Dimension 4700C User Manual
Page 15
1.
Follow the procedures in "
Before You Begin
."
2.
Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3.
Open the computer cover
.
4.
Disconnect the flex cable assembly from the back of the CD drive.
5.
Disconnect the USB cable on the back of the Flash Card Reader from the front-panel USB connector on the
system board
.
6.
Disconnect the IEEE 1394 connector on the
system board
.
7.
Release the cable from the cable routing clip.
8.
Press in on the release tabs at each end of the media bracket and slide the unit out.
9.
Reconnect the flex cable assembly to the back of the CD drive.
10.
Installing a Flash Card Reader
1.
Follow the procedures in "
Before You Begin
."
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.