Dell UPS 1000T - Manual (Page 11)

Dell UPS Management Software: Common Software Installation Scenarios
11
To set the power source:
Click “Shutdown” menu  “Edit Power Source”  Select primary ULNM agent from drop-down
menu, add primary ULNM credentials, and save the settings. Confirm that the Dell UPS is now seen
in the “Power Source” menu item.
Figure 8: ULNM edit power source
Figure 9: Power source information and status
To configure shutdown settings:
The procedure is the same as for the primary server ULNM.
Click “Shutdown” menu  “Edit Shutdown Configuration” and make the appropriate settings. For
an explanation of shutdown timer settings, refer to Appendix 2.
To support automatic server restart after a shutdown event, ensure that the “Outlet Shutoff
Active” box is checked and check the server BIOS settings to ensure that “Auto Power On” or “Last
State” is set as active.