Figure 7. using template to mark vertical rails, Figure 7, Using template to mark vertical rails – Dell PowerVault 51F (8P Fibre Channel Switch) User Manual
Page 22
8
Dell PowerVault 56F Systems Rack Installation Guide
2.
Mark the rack’s front vertical rails with a felt-tipped marker or place self-adhesive
masking tape where the switch’s upper and lower edges will be located (see Fig-
ure 7). Make a mark or place tape on the vertical rails next to the template’s
V-shaped notches.
# $%& '%%
3.
At the front of the rack cabinet, position one of the slide assemblies so that its
fixed mounting bracket flange fits between the marks or tape you placed on the
rack, marking the upper and lower edges of the template. The hooks on the
mounting bracket should align with the marks you made from the V-shaped
notches in the template.
4.
Align the slide-assembly mounting-bracket flange (on the front of the slide
assembly) with the square holes in the front vertical rail (see Figure 8).
template
2 U (3.5 inches) between
slide assemblies
(drawing is not to scale)
886nceb0.book Page 8 Friday, April 14, 2000 9:37 AM