Dell Inspiron 23 (2350, Mid 2013) - Manual (Page 56)

56 | Removing the Stand Assembly
Procedure
1 Gently peel off and release the antennas from the alignment posts on the
display bezel.
2 Press the securing clips and disconnect the LVDS cable from the display panel.
3 Disconnect the control-buttons board cable from the control-buttons board.
4 Disconnect the power-button cable from the control-buttons board cable.
5 Remove the screws that secure the cables to the display bracket.
NO TE: Note the routing of the cables before you remove them so that you can
route them correctly after you replace the stand assembly.
1 screws (3) 2 left antenna
3 LVDS cable 4 securing clips
5 power-button cable 6 control-buttons board cable
7 alignment posts (2) 8 right antenna
3
1
8
4
5
6
7
2
book.book Page 56 Thursday, August 1, 2013 1:03 PM