Dell PowerVault NX3100 User Manual
Page 52
52
Appendix
The wizard was unable to import one or more
virtual disks. Make sure that the files are not in
use, and then run the wizard again.
•
Initiator fails to discover a Target using the DNS domain name— When
configuring Initiator access to an iSCSI Target, IQNs are the preferred
method and work regardless of DNS configuration. The option of
specifying a DNS domain name is built into the Microsoft iSCSI Software
Target snap-in. If you prefer to use DNS names, ensure that DNS is
configured correctly (including forward and reverse lookup zones) and
specify the fully qualified domain name (FQDN) of the Initiator. If you
have difficulty in connecting the Target to the Initiator after specifying the
Initiator FQDN, run the following command on the target server to check
that DNS reverse lookup is enabled correctly:
nslookup
iSCSI Initiator.
If the nslookup command fails, it indicates that DNS reverse lookup is not
configured. Reconfigure the Target to use the Initiator IQN, IP address, or
MAC address. Alternatively, you can use a NetBIOS name to connect the
Initiator, fulfilling the following conditions:
–
No DNS reverse lookup zones are configured for the subnet used by
the Target.
–
Network Discovery or File Sharing is enabled on Initiator and Target
servers.
•
Shadow copies of local-mounted volumes—It is recommended that you do
not make shadow copies of local-mounted volumes. When you locally
mount a virtual disk and then try to make a shadow copy of that volume
using Windows Explorer, the storage appliance appears to hang. This is
because of the way shadow copies are created. When you make a shadow
copy of a locally mounted virtual disk, the local mount driver writes to the
underlying volume hosting the virtual disk. This causes an additional write
to the differencing area on the host volume. The result is a circular series
of writes that eventually cause the storage appliance to stop responding. If
you encounter this scenario, restart the storage appliance.
•
Initiator fails to restore a lost connection—The Initiator may fail to restore
a lost connection due to bad IP addresses. In some cases where the iSCSI
Initiator loses communication with Microsoft iSCSI Software Target, the
Initiator may appear to hang while reconnecting. This issue occurs if the