Dell UPS 1000T - Manual (Page 82)

82 |
Operation and Maintenance
S
Modify Network settings: To modify existing network parameters (see Figure 42). Restart the card
to activate the new parameters. In DHCP mode, the card can receive the following parameters
according to the DHCP server settings:
- IP address
- Subnet mask
- Gateway address
NOTE: You cannot configure the IPv6 address through the serial link. The IPv6 address is provided by the card
or by the IPv6 DHCP server (if an IPv6 DHCP server is available on the network). See “Network Settings” on
page 49 to enable the IPv6 feature and configure IPv6 settings.
For each of the following questions, you can press to select the
value shown in braces, or you can enter a new value.
Should this target obtain IP settings from the network?[N]
Static IP address [166.99.18.129]?
Subnet Mask IP address [255.255.248.0]?
Gateway address IP address [166.99.17.1]?
Wait while your new configuration is saved ...
Reset the card to enable the new configuration.
Figure 42. Modify Network Settings