Dell UPS 1000T - Manual (Page 37)

37 Configuring the Card |
UPS Control
Click UPS Control from the menu bar to open the UPS Control page (see Figure 22).
Figure 22. UPS Control Page
The UPS Control page enables triggering of startup and shutdown sequences for the UPS main output
and load segments.
The status of each output displays by a icon associated with the Off label (red icon) or On label (green
icon).
The shutdown sequences allow time for the registered servers to shut down without losing data (see
“Shutdown Parameters” on page 40).
The Inverter has priority over the load segments. Shutdown of the Inverter causes the load segments to
shut down. Load segments can be started only if the Inverter is on.
The list in the Control column displays the following commands, which are initialized by clicking
Execute. These commands include:
S
Safe power down: Immediately launches a sequence to switch off output power. The command
shuts down the supplied systems while the shutdown sequence is running, then switches off the
output.