CyberData VoIP Loudspeaker Amplifier Part #010859 - Manual (Page 25)

Installing the VoIP Loudspeaker Amplifier
Configure the Loudspeaker Amplifier Parameters
VoIP Loudspeaker Amplifier Operations Guide 930111F CyberData Corporation
17
2.3.2 Configure the Network Parameters
1. Click the Network Setup button to open the Network Setup page ( Figure 2-13 ).
Figure 2-13. Network Setup Page
2. On the Network Setup page, enter values for the parameters indicated in Table 2-9 .
Table 2-9. Network Setup Parameters
Web Page Item Description
IP Addressing* Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
Table 2-9 . If you select DHCP,
go to Step 3 .
IP Address* Enter the static IP address.
Subnet Mask Enter the Subnet Mask address.
Default Gateway Enter the Default Gateway address.
DNS Server 1* Enter the DNS Server 1 address.
DNS Server 2* Enter the DNS Server 2 address.
Click this button to save your configuration settings. Changing a
parameter that has an asterisk next to it will cause a system reboot
when saved.