Dell Dimension 9100 - Manual (Page 25)

5. Pull the sliding plate to the right and hold in place.
6. Slide the floppy drive out of the floppy drive bay.
Installing a Floppy Drive
1. If you are installing a new floppy drive, remove the shoulder screws from the inside of the drive-panel insert and attach the screws to the new drive.
2. Slide the floppy drive into the floppy drive bay until the sliding plate clicks into place and the drive snaps into position.
3. Attach the power and floppy-drive cables to the floppy drive.
4. Connect the other end of the floppy-drive cable to the connector labeled "FLOPPY" on the system board. For more information on the system board, see
"
System Board Components ."
5. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
6. Close the computer cover.
7. Connect your computer and devices to their electrical outlets, and turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network port or device and then plug it in to the computer.