Dell Precision M2400 (Mid 2008) User Manual
Page 32
32
Troubleshooting
If your computer beeps during start-up:
1 Write down the beep code.
2 Run the Dell Diagnostics to identify a more serious cause (see "Dell
Code
(repetitive
short beeps)
Description
Suggested Remedy
1
BIOS checksum
failure. Possible
motherboard failure.
Contact Dell.
2
No memory modules
detected
1
If you have two or more memory modules
installed, remove the modules, reinstall one
module (see your
Service Manual at
support.dell.com), and then restart the
computer. If the computer starts normally,
reinstall an additional module. Continue until
you have identified a faulty module or
reinstalled all modules without error.
2
If available, install good memory of the same
type into your computer see your
Service
Manual at support.dell.com).
3
If the problem persists, contact Dell.
3
Possible system
board failure
Contact Dell.
4
RAM Read/Write
failure
1
Ensure that no special memory
module/memory connector placement
requirements exist (see your
Service Manual at
support.dell.com).
2
Verify that the memory modules that you are
installing are compatible with your computer
(see your
Service Manual at
support.dell.com).
3
If the problem persists, contact Dell.
book.book Page 32 Tuesday, July 22, 2008 10:56 AM