beautypg.com

Dell Studio Desktop D540 (Late 2008) User Manual

Page 22

background image

Back to Contents Page

 

Replacing Memory Module(s)

Dell Studio™ 540 Service Manual 


 

 

1.

Follow the procedures in

Before You Begin

.


 

2.

Remove the computer cover (see

Replacing the Computer Cover

).


 

3.

Locate the memory modules on the system board (see

System Board Components

).


 

4.

Press out the securing clip at each end of the memory module connector.


 

5.

Grasp the module and pull it upwards.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

 

6.

Ensure that you install a single memory module in DIMM connector 1, the connector closest to the processor, before you install modules in any other
connector.

 

7.

Align the notch on the bottom of the module with the with the tab on the memory module connector.

CAUTION:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

1

securing clip

2

memory module connector

NOTICE:

Do not install ECC memory modules.

NOTICE:

If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that

you may have, even if you purchased the new modules from Dell™. If possible, do not pair an original memory module with a new memory module. 
Otherwise, your computer may not start properly. The recommended memory configurations are:
A pair of matched memory modules installed in DIMM connectors 1 and 2.
or
A pair of matched memory modules installed in DIMM connectors 1 and 2 and another matched pair installed in DIMM connectors 3 and 4.

NOTE:

If you install mixed pairs of PC2-5300 (DDR2 667-MHz) and PC2-6400 (DDR2 800-MHz) memory, the modules function at the speed of the slowest

module installed.

1 Pair A: matched pair of memory

modules in connectors DIMM_1
and DIMM_2

2 Pair B: matched pair of memory

modules in connectors DIMM_3
and DIMM_4