Dell PowerEdge Rack Enclosure 4210 - Manual (Page 9)

Cable Routing Procedures for the Dell PowerEdge T320 & T420 Systems
9
Section 3: Cabling a PowerEdge T320 & T420 system without a
CMA
NOTE: The CMA for Dell PowerEdge T320 & T420 is optional. Without the CMA installed, the system
must be powered down and all cables disconnected before it can be extended out of the rack.
1. Connect all applicable cables to the rear of the system and verify that all connections are secure.
2. Using the hook-and-loop straps supplied with the rail kit, bundle the cables and secure them to
either the left or right CMA attachment bracket as described in the Rack Installation Instructions.
See Figure 7 for an example of data cables secured to the left CMA bracket and power cables
secured to the right CMA bracket (as viewed from the rear of the system).
3. It is recommended that the cables be secured to the outer brackets, but cables may be secured to
the inner brackets if desired.
Cable routing without a CMA Figure 7.