Clearing cmos passwords – Dell Inspiron One 2310 (Late 2010) User Manual
Page 81
6.
Wait for approximately five seconds to clear the password setting.
7.
Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
8.
Replace the system-board shield (see
Replacing the System-Board Shield
).
9.
Replace the back cover (see
Replacing the Back Cover
).
10.
Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Passwords
1.
Follow the instructions in
Before You Begin
.
2.
Remove the back cover (see
Removing the Back Cover
).
3.
Remove the system-board shield (see
Removing the System-Board Shield
).
4.
Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board. (see
System Board Components
).
5.
Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
Inspiron One 2305
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
WARNING:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
WARNING:
The computer must be disconnected from the electrical outlet to clear the CMOS setting.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).