Rear stand cover, Removing the rear stand cover, Replacing the rear stand cover – Dell Inspiron One 2310 (Late 2010) User Manual
Page 71
Back to Contents Page
Rear Stand Cover
Dell™ Inspiron™ One 2305/2310 Service Manual
Replacing the Rear Stand Cover
Removing the Rear Stand Cover
1.
Follow the instructions in
Before You Begin
.
2.
Remove the back cover (see
Removing the Back Cover
).
3.
Follow the instructions from
step 2
to
step 5
in
Removing the Front Stand
.
4.
Lift and hold the rear stand and release the rear stand cover from its position.
5.
Slide out the rear stand cover through the rear stand.
Replacing the Rear Stand Cover
1.
Follow the instructions in
Before You Begin
.
2.
Slide the rear stand cover through the rear stand.
3.
Lift the rear stand and place the rear stand cover in position.
4.
Follow the instructions from
step 4
to
step 5
in
Replacing the Front Stand
.
5.
Replace the back cover (see
Replacing the Back Cover
).
6.
Connect your computer and all attached devices to electrical outlets, and turn them on.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
rear stand cover
2
rear stand
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.