Dell Inspiron 1764 (Early 2010) - Manual (Page 57)

Back to Contents Page
USB Connector
Dell™ Inspiron™ 1764 Service Manual
Removing the USB Connector
Replacing the USB Connector
Removing the USB Connector
1. Follow the procedures in Before You Begin .
2. Remove the battery (see Removing the Battery ).
3. Follow the instructions from step 3 to step 19 in Removing the System Board .
4. Remove the screw that secures the USB connector to the computer base.
5. Lift the USB connector out of the computer base.
Replacing the USB Connector
1. Follow the procedures in Before You Begin .
2. Place the USB connector in the computer base.
3. Replace the screw that secures the USB connector to the computer base.
4. Follow the instructions from step 5 to step 24 in Replacing the System Board .
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery ) before working inside the
computer.
1 screw 2 USB connector
3 USB connector cable
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.