Dell PowerVault MD3000 - Manual (Page 24)

24
Storage Array
7 Press to set the
speed to 115200.
8
P ress to set the data , parity , and stopbits to 8-N-1 , then
press .
9 Press to exit the Comm Parameters screen.
10 Select Exit and press again to exit the setup screen.
Reset Password
NOTICE:
Failure to stop data I/O to a non-fault-tolerant array before performing the
following steps may result in loss of data.
1 Stop all I/O to the array.
2 From the HyperTerminal (Windows) or MINICOM (Linux) window, press
.
3 At the SPECIAL OPERATIONS MENU, press <1>, <0>, and
.
4 At the SERIAL INTERFACE MODE MENU, press <1> and ,
then and .
5 At the BOOT OPERATIONS MENU, press and to
restart the controller. Text scrolls across the screen as the controller
reboots.
6 Once Controller 0 has fully booted (look for
sodMain complete in the
HyperTerminal or MINICOM window), press .
7 At the prompt, type
clearSYMbolPassword (must use exact case)
and press .
The return value = 0 = 0x0 indicates that the password has been
reset /deleted.
8 Close HyperTerminal or MINICOM.
9 Remove password reset cable.
10 To set a new password, go to the Modular Disk Storage Manager software
under the Tools tab and click Set Or Change Password Link.
11 Leave the Current Password blank, enter the new password twice, and
click OK.